Powerplus POW64115 CHAINSAW 37.2CC 406MM EN Manuel d'utilisateur télécharger pdf (Page 22)

POW64115 EN

10.5 Spark plug

Note: for efficient operation of saw engine, spark plug must be kept clean

and properly gapped.

fig 18a

 Push stop switch down.

 Remove knob (A) holding air filter cover in

place; remove the top cover (B) by

loosening the cover retaining screw. Cover

will lift off. (fig. 18a)

fig 18b

 Disconnect the wire connector (C) from the

spark plug (D) by pulling and twisting at

the same time (fig. 18b).

 Remove spark plug with spark plug socket

wrench.

 DO NOT USE ANY OTHER TOOL

 Check electrode gaps with wire feeler gauge and set gaps to .025” (.635mm) if necessary.

 Reinstall a new spark plug.

Note: a resistor spark plug must be used for replacement.

Note: this spark ignition system meets all requirements of the interference-

causing equipment regulations.

11 CLEANING AND MAINTENANCE

11.1 Sprocket tip lubrication:

Caution: the sprocket tip on your new saw has been pre-lubricated at the

factory. Failure to lubricate the guide bar sprocket tip as explained below

will result in poor performance and seizure, voiding the manufacturer’s

warranty.

Lubrication of the sprocket tip is recommended after 25 hours of use or once a week, which

ever occurs first. Always thoroughly clean guide bar sprocket tip before lubrication.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

Pas de commentaire

Powerplus POW64115 CHAINSAW 37.2CC 406MM EN Manuel d'utilisateur Page 22